With the help of a homemade handle-holder with an emphasis, you can even cut sheet metal or sheets of plywood and OSB (saw blade on wood).
You can make a handle-holder for a grinder from scraps of metal that can be found in every workshop or garage.
The first step is to cut a piece of round pipe of suitable length. After that, you need to make markings and drill holes with the same pitch.
You will also need a small piece of a square shaped pipe, in the middle of which you need to drill a hole of the same diameter as in a round pipe.
The main stages of work
Next, it will be necessary to cut a piece of profile 12 cm long. It must be welded at right angles to a short segment.
At the next stage, the master cuts off three pieces of a metal plate, in two of which holes need to be drilled. Then all three plates are ground and welded together.
After that, it remains only to weld the mount to the end of the round pipe and paint the product with paint from a spray can. On this homemade product is ready.
In detail about how to make a simple home-made handle-holder with an emphasis for a small grinder, you can watch in the video on the website. Write in the comments, did you like this device?
