Surely, many were faced with a situation where, in order to remove a tight-fitting hose from a water pipe in a country house, one had to exert enormous efforts. To save time, the author suggests making a simple adaptation.
For the manufacture of this homemade product a bearing is required - it is better, of course, to use an old bearing for this. The first step is to remove the inner clip, and cut it into two halves.
After this, it is necessary to cut off two pieces of a strip of metal, and weld them to these halves from the outside. The metal in the place of welding must first be cleaned with a grinder from dirt and rust.
The process of making a homemade device
At the next stage, one of the parts of the fixture is welded to a long segment of the strip, and the second is attached to a square bar with a bolt and nut. First, you need to drill a hole in it and cut the thread.
Next, a second handle is made from a section of a square bar. Then it remains to clean all the parts and assemble the fixture.
By the way, this homemade product can be used not only in the country to remove the rubber hose, but also for other purposes. For example, for loosening nuts or bolts of large diameter in a home workshop and garage. In general, the universal thing turned out.
For more information on how to easily remove a tight-fitting rubber hose from a pipe using a simple homemade device, see this video.
