Share
Pin
Tweet
Send
Share
Send
• Select a pattern.
• Wall preparation.
• Mixing the solution.
• Outline.
• Execution of scenery.
Choice of drawing.
The Internet or your own imagination will help you decide on a suitable pattern. It can be a bunch of grapes, leaves, flowers, etc. The main thing is that the picture does not contain small details. It would be more difficult to create such a decoration, and it would look worse than simple.
Wall preparation.
Having decided on the pattern and its location on the wall, we draw its approximate contours.
Further, at this stage, you need to ensure a good bundle of future decoration with a fence. To do this, on the site of the future decoration, you need to make shallow notches with the help of a grinder or some sharp object.
Such procedures will ensure the strength of the connection and prevent the fake from disconnecting and falling in the future.
Kneading solution.
For the manufacture of scenery requires a normal solution of sand, cement and water. Three to four parts of sand must be moved with one part of cement. Water is poured into the resulting mixture and all this is thoroughly kneaded. Water must be added until dry lumps remain in the solution.
But do not overdo it - it is hard to work with a strongly liquid solution. A drop of detergent can be added to the finished mixture. This will make the solution more elastic, it will not quickly "sit down".
Outline
The prepared solution must be thrown with a trowel into the place of future decoration with a thick layer (1.5 - 3 cm). In order for the solution to stick well and not fall off, the throws should be sharp and clear. It is not worthwhile to press the "flat cakes" that are badly attached to the fence with a trowel - it is better to tear them and throw them again. Smoothing cakes is also not necessary.
Execution of scenery.
After sketching the solution, you need to give it a little time to "grasp". And after about ten to fifteen minutes you can begin to art. With the help of some twig, the necessary pattern or pattern is scraped out, excess cement is removed.
Further, using a regular paint brush, periodically wetting it in water, all the sharpness and roughness of the decoration are smoothed out. If necessary, you can use a foam grater, which is very convenient to smooth the plane.
Everything, the decoration is ready!
After the decoration has dried, you can paint it either with pure cement, dissolved in water, or with the addition of colored pigment. This will give the manufacture a peculiar shade. You can paint your work of art with ordinary paints, but it is not advisable, since simple paint can fade and peel over time.
Drawings of bricks on fences are made in a similar way.
But here it’s not necessary to be an artist at all - all lines are marked with the help of a level and a tape measure.
So, you can easily and simply give a second breath and freshness to the old, gray cement fence!
Share
Pin
Tweet
Send
Share
Send